CommScope Era Installation Manual Download

Page: 20 / 71

CommScope Era

™

Fiber Low Power Carrier Access Point Installation Guide

M0201ANC_uc

Page 16

© June 2019 CommScope, Inc.

Plan and Prepare for a Fiber CAP L Installation

Notice:

For a Class A digital device or peripheral.

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.

Note:

This unit complies with European standard EN60950-1 / EN62368-1.

Equipment Symbols Used / Compliance

Please observe the meanings of the following symbols used in our equipment and the compliance warnings
listed in

Table 5

Table 5.

Compliance Labels

Symbol

Compliance Meaning

—

FCC

For industrial (Part 20) signal booster:

WARNING: This is NOT a CONSUMER device. It is designed for installation by FCC LICENSEES and
QUALIFIED INSTALLERS. You MUST have an FCC LICENSE or express consent of an FCC Licensee to
operate this device. Unauthorized use may result in significant forfeiture penalties, including
penalties in excess of $100,000 for each continuing violation.

For (Part 90) signal booster:

WARNING: This is NOT a CONSUMER device. It is designed for installation by FCC LICENSEES and
QUALIFIED INSTALLERS. You MUST have an FCC LICENSE or express consent of an FCC Licensee to
operate this device. You MUST register Class B signal boosters (as defined in 47 CFR 90.219) online
at

www.fcc.gov/signal-boosters/registration

. Unauthorized use may result in significant forfeiture

penalties, including penalties in excess of $100,000 for each continuing violation.

—

ISED

WARNING: This is NOT a CONSUMER device. It is designed for installation by an installer approved
by an ISED licensee. You MUST have an ISED LICENCE or the express consent of an ISED licensee to
operate this device.

AVERTISSEMENT: Ce produit N'EST PAS un appareil de CONSOMMATION. Il est conçu pour être
installé par un installateur approuvé par un titulaire de licence d'ISDE. Pour utiliser cet appareil,
vous DEVEZ détenir une LICENCE d'ISDE ou avoir obtenu le consentement exprès d'un titulaire de
licence autorisé par ISDE.

To be sold exclusively to mobile operators or authorized installers - no harmonized frequency
bands, operation requires license. Intended use: EU and EFTA countries.

Indicates conformity with the RED directive 2014/53/EU and/or RoHS directive 2011/65/EU.

Required Antenna Distances

Table 6.

Required Antenna Distances

CAP L Model

Antenna gain

without cable

loss [dBi]

Minimum Distance Between Antennas and All Persons

FCC

ISED

Meters