ADCP-96-167 • Issue 5 • July 2016
Page 20
© 2016, CommScope, Inc.
2. Using the mounting bracket as a guide, mark the location of the bracket mounting
holes on the masonry wall as shown in
.
Figure 12. Installing Mounting Bracket on a Masonry Wall
3. Drill a 5/8-inch hole (check hole size with anchor manufacturer) in the wall at each
of the locations marked in step 2.
4. Secure the mounting bracket to the masonry wall using the two 3/8-inch x 1-1/2-
inch cap screws, two 3/8-inch lock washers, and two 3/8-inch flat washers.
Tighten cap screws securely.
5. Using appropriate lifting equipment, hoist the cabinet into position for attachment
to the mounting bracket.
6. Hang the cabinet from the installed mounting bracket. The welded bracket on the
) fits into the two slots at the top of the mounting
bracket. The partially installed cap screw at the bottom of the mounting bracket fits
into the slotted tab at the bottom of the cabinet.
Note:
Locate the mounting anchors as close as possible to the center of bricks or
blocks.
Danger: Do not stand directly under the cabinet as it is being hoisted into position for cable
installation. A failure of the lifting equipment could result in serious personal injury.
24218-A
MOUNTING
BRACKET
3/8 x 1-1/2-INCH
CAP SCREW (2)
3/8-INCH FLAT
WASHER (2)
3/8-INCH
CONCRETE
ANCHOR (2)
MASONRY
WALL
3/8-INCH LOCK
WASHER (2)