ADCP-93-095 • Rev B • April 2018
Page 16
© 2018, CommScope, Inc.
5.5.1
Cable Routing for 7-Inch and 9-Inch High Panels
Use the following procedure to route the feeder cable within the rear storage area and on the
rear door splice deck. Refer to
.
1. Route the cable from the entry hole horizontally across the rear storage area and form a
single vertical loop by looping the cable twice through the rear set of curleyloks (following
the same route as the internal pigtails in the front set of curleyloks).
2. Route the cable to the splice area access door.
3. Tie down the cable at the point where the exposed fibers emerge from the breakout per the
breakout dimensions provided in
Figure 14. Cable Routing (7- and 9-Inch High Panel)
CABLE
CLAMP
SPLICE AREA
ACCESS DOOR
LOOP TWICE
THROUGH
CURLEYLOKS
IN SAME LOOP
AS PIGTAILS
17602-A
MASS FUSION
SPLICE CHIP
ENTRY
HOLE
REAR VIEW
BREAKOUT
POINT
