Page 4 of 8
© 2019 CommScope, Inc. All Rights Reserved
7
Install branch cable (8-11 mm)
7.3.1
Remove the jacket over a length of 1 m (or 2 m if
window cut). Prepare the cable jacket with a piece of foam
and secure it with cable ties as shown.
7.3.2
Secure the strength member (35 mm) or aramid
yarn with the metal plate and screw.
7.3.3
Route the fiber bundle and fibers the same way as
for the main cable. (See section 6.3)
8
Install organizer in housing
8.1
Install the organizer in the housing as shown. Bring
in under an angle of 45°.
8.2
Tighten the 2 top screws.
6.3.3
Strip the tube at 15 cm from the jacket end and
clean the fibers before routing them to the tray
.
6.3.4
Secure the loose tube with 2 cable ties as shown.
6.3.5
Store the fibers on the tray. Changing direction is
possible with figure 8, see picture above.
6.3.6
Secure the trays as shown.
