ADCP-93-080 • Rev B • April 2018
Page 5
© 2018, CommScope, Inc.
2.2 Two Cables Per Entry Port (Figure 2B)
Use this procedure to install a second cable.
1. Cut out the appropriate size openings in the grommet that is the closest in size
to the outside diameter for the cable being installed.
2. Attach the second set of clamp yokes to the clamp already in position.
a. Place the spacer bracket over the bolt heads of the first clamp. Ensure the
bolt heads are aligned to allow the bracket to slide over the bolt heads.
b. Thread a male/female bolt through the top holes of the second set of clamp
yokes into the top male/female bolt of the first clamp. Do not tighten at
this time.
3. Route the cable through the hole cut in the grommet and into the cable clamp.
Use split grommets as required to assure a tight fit. Thread the lower bolt
through the bottom holes of the clamp yokes. Check that the spacer bracket is
in place and tighten both bolts.
Note:
Do not remove the spacer bracket after the bolts are tightened.
4. Connect the ground straps to the cable terminating and grounding plate as
.
2.3 Three Cables Per Entry Port (Figure 2C)
Use this procedure to install a third cable.
1. Cut out the appropriate size openings in the grommet that is the closest in size
to the outside diameter for the cable being installed.
2. Attach the third set of clamp yokes to the clamp already in position.
a. Place the spacer bracket over the bolt heads of the second clamp. Ensure
the bolt heads are aligned to allow the bracket to slide over the bolt heads.
b. Thread a male/female bolt through the top holes of the third set of clamp
yokes into the top male/female bolt of the second clamp. Do not tighten at
this time.
3. Route the cable through the hole cut in the grommet and into the cable clamp.
Use split grommets as required to assure a tight fit. Thread the lower bolt
through the bottom holes of the clamp yokes. Check that the spacer bracket is
in place and tighten both bolts.
Note:
Do not remove the spacer bracket after the bolts are tightened.
4. Connect the ground straps to the cable terminating and grounding plate as
.