www.commscope.com
860452168
Instruction Sheet
Page 17 of 21
Fiber Management When Using Stackable Splice Trays
1. Trim all pigtail lengths to 3 feet (1 meter) or less.
2. Perform fusion splicing operations per best practices and snap splice sleeves into holders provided inside of
tray.
3. Wind and dress fibers from buffer tube(s) into tray.
4. Wind and dress pigtails into tray.
5. After tray is fully populated, snap on clear plastic top cover.
6. Terminate a fiber pigtail into panel, color keying as required. Repeat for all remaining locations.
7. Repeat items 1-6 for any/all additional trays.
Step 6 – Return Internal Mechanism to Normal Position and Secure
Pivot internal mechanism up into position parallel to shelf bottom and slide inside shelf outer enclosure, as
shown in figure on previous page.
CAUTION:
Assure that no fiber slack becomes pinched or bent.
1. Secure bulkhead with two captive fasteners.
2. Align front door with front hinge slots, insert, close door, and rotate door fasteners to secure.
3. This completes the installation of the 360G2 extended depth, front access fiber optic combination shelf.
Plastic snap
rivets
3 trays
stacked
Bundle buffer
tubes on interior
of shelf
!
