Section 11–Adjusting Downtilt-Single Antenna with Multiple Actuators
ATC200-LITE-USB Teletilt
®
RET System
11-2
October
2014
Bulletin 639536 • Revision L
4. The
Set Actuator Position
screen will appear (Figure 11-2).
Note, all parameters that can be configured are displayed on this screen. This information may
be used as a reference to help determine the new tilt setting. However, configuration items
cannot be changed from this screen. All changes to configuration items must be done with the
Configuration screen as discussed in Section 6.
5. Enter the new angle in the
New Tilt
text entry field to change the electrical downtilt. Note that
the allowed range of angle values is displayed in the
Min Electrical Tilt
and
Max Electrical Tilt
fields in the top part of the screen. Any downtilt angle within this range may be entered. Downtilt
is controllable with a precision of 0.1 degree. Other axes may use whole degree precision
(Figure 11-2).
Examples: Five degrees downtilt may be entered as
5
or
5.0
. A downtilt of five and one-half
degrees would be entered as
5.5
.
6. Click
the
Activate
button (Figure 11-2) to apply changes to the electrical downtilt for this an-
tenna. Alternately, to exit the screen without sending any changes, click on the
Close
button.
Antenna movement will begin after the
Activate
button is applied.
A progress indicator bar (located to the left of
Current Tilt
) will continually update for as long as
the move is in progress.
Figure 11-2. Configuring New Electrical Downtilt Setting.
1.
ngle
may
be entered with the precision of 0.1 degree (Ex: 5.0 or 5.5).
Progress
Display.
Summary of Contents for Teletilt ATC200-LITE-USB
