v
Q
ui
ck
S
ta
rt
G
ui
de
iii
European Union Regulatory Conformance
The equipment complies with the RF Exposure Requirement 1999/519/EC, Council
Recommendation of 12 July 1999 on the limitation of exposure of the general public to
electromagnetic fields (0–300 GHz). This equipment meets the following conformance standards:
EN301489-1, -7, EN 301 511, EN62209-1, EN60950.
Changes or modifications to this product not authorized by the manufacturer could void the EMC
compliance and negate your authority to operate the product. This product has demonstrated EMC
compliance under conditions that included the use of compliant peripheral devices and shielded
cables between system components. It is important that you use compliant peripheral devices and
shielded cables between system components to reduce the possibility of causing interference to
radios, televisions, and other electronic devices.
We, hereby, declare that this cellular radio is in compliance with the essential requirements and
other relevant provisions of Directive 1999/5/EC.
SAR Information
THIS MOBILE DEVICE MEETS GUIDELINES FOR EXPOSURE TO RADIO WAVES. Your mobile
device is a radio transmitter and receiver. It is designed not to exceed the limits for exposure to radio
waves recommended by international guidelines. These guidelines were developed by the
independent scientific organization ICNIRP and include safety margins designed to assure the
protection of all persons, regardless of age and health.
The exposure guidelines for mobile devices employ a unit of measurement known as the Specific
Absorption Rate or SAR. The SAR limit stated in the ICNIRP guidelines is 2.0 W/kg averaged over
10 grams of tissue. Tests for SAR are conducted using standard operating positions with the device
transmitting at its highest certified power level in all tested frequency bands. The actual SAR level of
an operating device can be below the maximum value because the device is designed to use only
the power required to reach the network. That amount changes depending on a number of factors
such as how close you are to a network base station. The highest SAR value under the ICNIRP
guidelines for use of the device at the ear is 0.937 W/kg. Use of device accessories and
enhancements may result in different SAR values. SAR values may vary depending on national
reporting and testing requirements and the network band. Additional SAR information can be found
on the Cellullar Telecommunications Industry Association (CTIA) website at www.wow-com.com.
Q
uic
k S
tar
t G
uid
e
iv
FCC Regulations:
• This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
• This device has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiated radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
• The antenna(s) used for this transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter.
This model phone meets the government’s requirements for exposure to radio waves.
This phone is designed and manufactured not to exceed the emission limits for exposure to radio
frequency (RF) energy set by the Federal Communications Commission of the U.S. Government.
The exposure standard for wireless devices employs a unit of measurement known as the Specific
Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg. *Tests for SAR are conducted
using standard operating positions accepted by the FCC with the phone transmitting at its highest
certified power level in all tested frequency bands. Although the SAR is determined at the highest
