PROGRAMMING ROLLING CODE REMOTE CONTROLS :
1, MEMORY CLEARANCE
2, PRESS AND HOLD BUTTON 1 OF DUPLICATOR TILL LED FLASHES TWICE AND OFF, PRESS BUTTON 2
ONCE WHILE KEEP HOLDING BUTTON 1,
THE DUPLICATOR INTO BFT COPYING MODE
3,PRESS AND HOLD BUTTON 1ST &2ND OF BFT SIMULTANEOUS (SEED CODE SENDING MODE), LED
ON DUPLICATOR WILL FLASHES TWICE
AND OFF, RELEASE BOTH BFT BUTTONS AND THEN PRESS ANY BUTTON OF BFT, LED ON DUPLICATOR
WILL FLASHES THREE TIMES THEN STAY
ON, WHICH INDICATES BFT COPYING DONE.
REMARKS: BUTTON 1 OF DUPLICATOR KEEP PRESSED FROM STEP 2 TILL 3 DONE.
DUPLICATOR TO SEND SEED CODE OF BFT: PRESS BUTTON 1 & 4 SIMULTANEOUS.
SPECIAL PROGRAMMING STEPS FOR BFT MITTO2 & MITTO4 (OLD VERSION)
IF YOU ERASE THE CODE BY MISTAKE, YOU CAN RESUME IT BY PRESSING AND HOLD BOTH OF THE
"3" AND "4" BUTTON ON THE REMOTE
CONTROLLERS AT THE SAME TIME, AFTER 10 SECONDS, THE LED FLASHES 2 TIMES AND TURN OFF
WHICH INDICATES THE CODE OF THE COPY
REMOTE CONTROLLER IS RESUMED.
RESUME
REMARKS
FOR FIXED CODE &LEARNING CODE REMOTE CONTROLS, THE DUPLICATOR WILL WORK AFTER
DUPLICATING.
BUT FOR THE ROLLING CODE BRAND LISTED ABOVE, PLEASE FOLLOW THE ORIGINAL MANUAL TO
PROGRAM THE DUPLICATOR TO RECEIVER AFTER DUPLICATING.
