Product
Guide
User and
Maintenance
Information
© 2010 by Community Products, LLC
TF45 DC6783 Revision
D
IMPORTANT
INFORMATION:
Please save this
product guide.
CUSTOMER SERVICE:
United States
PO Box 2
Ulster Park, NY 12487
Office hours: 9-5 EST
Phone (800) 777-4244
Fax (800) 336-5948
(845) 572-3468
www.CommunityPlaythings.com
Sales@CommunityPlaythings.com
H525
Art Island Top/Floor Easel
H520
Junior Art Island
Figure A
Operation
WARNING
c
Unit may tip when rolled sideways. Always push
from an end. Never move with children nearby.
Always disengage wheels after moving.
CAUTION
c
Removing the easel frame or engaging the
mobility needs two people.
To remove the easel frame, press the two yellow
buttons at the end and lift.
To install the tray, place it flat on the shelf and cen-
tered between the white brackets. Press back firmly,
one end at a time, until the tray snaps into place.
To remove the tray (see figure B) use fingers and
thumb to lever the tray away from the easel.
Recommended Use
This easel supports a wide variety of activities:
• children’s paintings
• dry-erase markers directly on the whiteboard
• big book display
• flip chart presentations
Floor Easel
1-3 years of age
Junior Art Island
2-5 years of age
WARNING
c
This product is intended for use by children of
immature judgement, therefore supervision is
required at all times. Never reconfigure the Art
Island with children nearby.
c
Only use Floor Easel on the floor, not on a table-
top. It may slide off.
Assembly
Products consist of the following:
H525 Art Island Top / Floor Easel containing:
• 1 frame
• 2 whiteboards
• 4 trays
• 4 shelf assemblies
• 10 magnets (for attaching paper)
H520 Junior Art Island includes:
• 1 H525 Art Island Top / Floor Easel
• 1 H521 Art Island Low Storage Unit containing:
1 low storage unit
1 wooden adjustable shelf
2 plastic tote dividers
If your shipment is incomplete, please contact
Customer Service.
To assemble the Art Island:
1. Open the easel frame all the way so the stays
are straight.
2. Place the easel frame on the storage unit (if
applicable) making sure all four latches engage.
3. Hang the four shelf/tray assemblies on the
lower cross-member.
4. Place the bottom edge of the whiteboard panel
in the white hooks.
5. Secure the whiteboard by positioning and
screwing the white clips tight to catch the sides
of the board (see Figure A).
Figure B
