INS_CLFEXCOAX_REV–
09/28/11
PAGE 3
PAss-ThROUGh PoE OPERATIOns FOR ThE CLFE1COAX
INSTALLATION AND OPERATION MANUAL
CLFE(X)COAX
TECh SUPPORT: 1.888.678.9427
Comnet’s Copperline ClFe1COAX extended distance iP data and Poe maintains the safety standards for communications found
within the 802.3af and 802.3at Poe standards. This is for the protection of products operating in the extended distance transmission
chain.
In the event of malfunctions the communication system is designed to shut down power transmission to avoid device
damage.
The ClFe1COAX can be powered by a local power source (12 Volts D.C. or 24 Volts A.C.) or from a single PSe source, such as a
network switch’s Poe port using its unique Pass Through Poe feature. This latter feature eliminates the need for ClFe1COAX local
power while also providing power for the camera.
Using the Remote and Local switch
Set the ClFe1COAX positioned closest to the camera as “remote”
Set the ClFe1COAX positioned closest to the PSe source to “local”
(See full installation instructions, Page 6)
setting the CLFE1COAX Position switch
The ClFe1COAX provides the ability to transmit both data and Poe over rG59 cable. while the ClFe1COAX is a transceiver as
part of the installation,
the devices must be set according to their position in the transmission line as the camera and control site
location
.
Powering The CLFE1COAX Transceivers
under normal operating conditions ClFe1COAX transceivers should be powered using the Poe source. external power to the
ClFe1COAX should be restricted to installations where a camera requires local power.
when installing the ClFe1COAX, the following conditions apply which will affect its operations.
The ClFe1COAX is provided with the ability to operate using a local external power supply. The standard accessory local power
adaptor plug can be used for power supplies that do not have the ClFe1COAX’s standard power input connector. when inserting
the adaptor into the power input, the ClFe1COAX is only powered from a local power source and not from a PSe source. The
camera will continue receiving power from the PSe source and operations will be normal.
However,
if the external plug adaptor is inserted in the CLFE1COAX and no power is applied
, the ClFe1COAX
will not
power up
even if a Poe source is present, the camera will continue to receive power. in this case the ClFe1COAX is not operational and no
data will flow.
Input with
external power
plug installed.
External
power adapter
(included)
