INS_CNXE2GE2TX8MSPOE 11 Jan 2021 PAGE 141
INSTALLATION AND OPERATION MANUAL
CNXE2GE2TX8MSPOE
TECH SUPPORT: 1.888.678.9427
6.8.4 ACL
Ports
Configure the ACL parameters (ACE) of each switch port. These parameters will affect frames
received on a port unless the frame matches a specific ACE.
Label
Description
Port
The switch port number to which the following settings will be applied
Policy ID
Select to apply a policy to the port. The allowed values are 1 to 8.
The default value is 1.
Action
Select to Permit to permit or Deny to deny forwarding. The default value is Permit.
Rate Limiter ID
Select a rate limiter for the port. The allowed values are Disabled or numbers from 1
to 15. The default value is Disabled.
Port Redirect
Indicates the port redirect operation implemented by the ACE.
Frames matching the ACE are redirected to the listed port.
Mirror
Select which port frames are copied to. The allowed values are Disabled or a specific
port number. The default value is Disabled.
Logging
Specifies the logging operation of the port. The allowed values are:
Enabled: frames received on the port are stored in the system log
Disabled: frames received on the port are not logged
The default value is Disabled. Please note that system log memory capacity and
logging rate is limited.
Shutdown
Specifies the shutdown operation of this port. The allowed values are:
Enabled: if a frame is received on the port, the port will be disabled.
Disabled: port shut down is disabled.
The default value is Disabled.
Counter
Counts the number of frames that match this ACE.
