INS_NWKBB200_REV– 06/10/13 PAGE 10
INSTALLATION AND OPERATION MANUAL
NWKBB200
TECH SUPPORT: 1.888.678.9427
Connect your device to the 48VDC @ 5A power source on Pins 1 and 2.
Connect AC Power Source to the Controller
Once AC power is detected, the LEDs on the front of the controller will light up.
Mains or Backup LED will be off when AC power is available and on when powered by the battery.
Low Battery or Battery Replacement LED indicates that the battery is below 30% capacity or will
stay on if a battery fault is detected.
The Diagnosis LED indicates charging mode.
1 Blink/Sec for Trickle Charge
2 Blink/Sec for Boost Charge
5 Blink/Sec for Recovery Charge
More detailed instructions will be provided with the controller for all other applications.
