CompAir Limited
page 30
MAINTENANCE
1.
ROUTINE MAINTENANCE
To ensure the efficient operation of the compressor
installation the user must check performance
regularly and carry out the necessary adjustments
to maintain correct settings. This section gives the
information needed by the user for this purpose.
Personnel accustomed to servicing and maintaining
mechanical equipment should have no difficulty in
carrying out these tasks but if assistance is needed
the user should refer to the local CompAir
Distributor .
Routine maintenance and regular servicing must be
carried out as recommended in the 'Maintenance
Schedule'.
A condition of the Warranty cover is that the user
must ensure that the compressor and auxiliary
equipment are properly maintained and adjusted,
that all checks and services listed in the Schedule
are carried out at the specified intervals and an
accurate record is kept of the work.
1.1 Cleanliness
The installation must be kept in clean condition at
all times. Inspect regularly for signs of damage,
excessive wear and security of fittings. Ensure that
any oil spillage is wiped up immediately and any
residual oil cleaned from external surfaces.
1.2 Recording Pressures and Temperatures
Keep a regular daily record of operating pressures
and temperatures. The readings should be taken
when conditions are stable and with the compressor
running on full load.
1.3 Maintenance Record
Keep a careful record of all servicing, maintenance
and repair work carried out on the compressor. The
record will form a useful reference and any variation
from normal operation will be noticeable
immediately, alerting the user to a possible need for
servicing or maintenance. Frequent recurrence of a
particular repair could reveal an unsatisfactory
operating condition which must be corrected.
1.4 Pressure Settings
Pressure switch settings and adjustments must be
maintained correctly to prevent faults occurring
which could reduce the efficiency of the compressor.
Refer to 'Adjustments' in the 'Operation' section of
this manual for details.
1.5 Electrical Connections
Avoid damage to electrical wiring when working on
the compressor installation and inspect wires and
cables before refitting. Ensure no damage will be
caused by chafing or contact with hot surfaces
when the unit is in service. Do not fasten wiring
directly to a line carrying fluid.
z
Refer to the safety procedures before carrying
out any maintenance or servicing work on the
compressor unit.
WARNING
z
Lethal voltages are used in this equipment.
Use extreme caution when carrying out
electrical checks. Isolate the power supply
before starting any maintenance work.
Summary of Contents for EO40/0001
