When you receive your scanner, it will be turned o
ff
. You will need to charge the scanner overnight
before using it.
The scanner comes with two batteries. Place the first battery in the cradle’s charger. Slide the
battery in label side down, inserting the end with the metal connectors first. Push down to snap the
battery into place.
Image 2 – Inserting battery into the cradle.
Hold the scanner with the trigger pointing towards the ceiling and the handle pointed towards you.
Insert the other battery, label side down, into the handle of the scanner. Push the battery in and
slide the locking mechanism on the battery up. Place the scanner on the cradle to charge the
battery.
Image 3 – Inserting the battery into the scanner.
Once the scanner has been charged, it will need to be “paired” with the cradle. Pairing the scanner
with the cradle instructs the scanner to send data back to the base which is plugged into your
machine and was devised so that multiple scanners could be used with unique cradles within
wireless range without interfering with one another.
To pair the scanner to your base, turn the cradle upside down. You will find 2 labels; the first label
has the words SET CONNECTION and a barcode. The second label is the serial number. To pair the
scanner to the cradle, scan the SET CONNECTION barcode label, the scanner will beep once, and
then scan the SERIAL number barcode. The scanner will beep twice, a low and then high beep. When
it establishes a connection with the cradle, the scanner will then emit three short ascending beeps.
Your pairing is established and you are now ready to use your scanner.
If you change batteries, the
scanner will lose its pairing.
If you have trouble scanning the SET CONNECTION barcode on the cradle, please scan the SET
CONNECTION barcode below, followed by the SERIAL number barcode on the cradle.
SET CONNECTION
!
IGS010.0—V1140 Bluetooth Wireless Linear Imaging Scanner
Page of
4
12
