Programming your Scanner
The wireless linear imager scanner o
ff
ers a variety of custom settings to fit your needs. The scanner
comes with a default setting for each option that is o
ff
ered. These default settings are indicated
throughout the programming guide with “< >” characters surrounding the name of the barcode
setting. There is no need to scan the preferred setting if it is the default, given that the scanner is
set to the default settings. Each time a default setting needs to be changed, these steps must be
followed:
Scan the “Enter Setup” barcode
Scan the new setting(s) for your scanner
Scan the “Update” barcode
When programming your scanner, the buzzer of the scanner will emit beeps. The following will help
you decipher those beeps.
•
Power on beep: the scanner will issue a long beep to indicate a successful power on.
•
Good read beep: one short beep
•
Error beep: the scanner will issue a long beep with a low tone to indicate errors.
•
Enter / Exit configuration beep: the scanner will issue 6 beeps upon entering / exiting the
configuration mode.
•
Setup beep: when you’re programming your scanner, the scanner will normally beep twice
when a setup barcode is read. If the program sequence requires more than one barcode in the
series, the scanner will only issue a short beep to indicate that there are more setup barcodes
needed to complete the current program sequence.
After scanning a programming barcode, a short pause is required before the confirmation tone
is heard. You will need to allow up to a ten second pause before proceeding to the next
programming barcode. The confirmation beep does not always occur.
The programming barcodes on the following pages are used for di
ff
erent modes that the scanner
can operate in.
If you have any questions or problems, please contact Technical Support at 1-800-347-4942 or
email
IGS010.0—V1140 Bluetooth Wireless Linear Imaging Scanner
Page of
5
12
