4-18
Compaq TFT5600 Rackmount Keyboard and Monitor (RKM) Maintenance and Service Guide
Removing the AC Brick
IMPORTANT:
You must remove the rear cover before you remove the AC brick.
To remove the AC brick:
1.
Disconnect all cables from their source.
2.
Unplug the AC brick from the controller board and lift the brick off of
the Velcro.
Figure 4-15. Removing AC brick
IMPORTANT:
Make sure the AC brick is properly located on the Velcro so that the rear
cover can be installed.
To replace the AC brick, reverse the above procedure.