Installing the Server Blade and Options
2-8
Compaq ProLiant BL20p Server Blade Setup and Installation Guide
COMPAQ CONFIDENTIAL
Writer: Christine Portillo File Name: c-ch2 Installing the Server Blade and Options.doc
Codename: AvX Part Number: 307131-001 Last Saved On: 11/1/02 1:02 PM
Installing the Access Panel
After installing all the options, reinstall the access panel:
1.
Set the access panel on top of the server blade. Allow the panel to extend past the
rear of the server blade approximately 1 cm (3/8 inch).
2.
Slide the access panel forward until it fits into place (1).
3.
Tighten the thumbscrew on the rear of the server blade (2).
Figure 2-5: Installing the access panel
Memory
You can expand system memory by installing Compaq synchronous DRAM
(SDRAM) DIMMs. A ProLiant BL20p server blade supports up to four 1-GB,
133-MHz, ECC, registered SDRAM DIMMs.
Identifying DIMM Slots
Use Figure 2-6 and Table 2-2 to identify DIMM slot locations. The slots are
numbered sequentially (1 through 4), and the paired banks are identified by the letters
A and B.
