QuickSpecs
StorageWorks NAS B3000 by Compaq
DA-11339
Canada — Version 7 — September 24, 2002
4
Standard Features
Proc es sor
Model N900, C900, N900s, C900s
Two (2) Intel Pentium III Xeon 900-MHz processors (upgradeable to 4)
Ca che M emor y
2-MB level 2 write back cache per processor standard
Memor y
Standard
2 GB (512 x 4 PC100MHz ECC SDRAM Memory with Advanced ECC functionality)
Maximum
4 GB
NOTE
: Advanced ECC Memory Technology protects the data even in the event of an entire SDRAM component
failure. Embedded in the chipset design, this feature allows the use of Industry-Standard Registered
DIMMs.
Upgrad abi li ty
Upgradeable to four processors, upgradeable to 4 GB of ECC SDRAM, upgradeable storage capacity
Ne twor k Con trol le r
Integrated Compaq NC3134 Fast Ethernet NIC 64 PCI Dual Base 10/100 in a slot and a Compaq NC3135 Fast
Ethernet NIC 64 PCI dual 10/100 daughter card (total 10/100 ports is 4) (Gigabit options available)
Hos t Ad apter s
FCA2101 Host Bus Adapter
Expan sion Slo ts
I/O (6 Total, 2 Available)
PCI Voltage:
Two (2) 64-bit/66-MHz PCI Hot Plug
1 available
3.3 Volt Only
Two (2) 64-bit/33-MHz PCI Hot Plug
0 available
5 Volt or 3.3 Volt
One (1) 64-bit/33-MHz PCI Non-Hot Plug 0 available
5 Volt or 3.3 Volt
One (1) 32-bit/33-MHz PCI Non-Hot Plug 1 available
5 Volt Only
NOTE
: One 64-bit/66-MHz PCI Hot Plug slot available and one 32-bit/33-MHz PCI Non-Hot Plug slot available
Stor age Con tro ll er
Integrated Smart Array Controller (Two channel) (supports Internal RAID 0, 1, 0+1, 5 and external tape devices)
Interna l Sto rag e
Diskette Drives
1.44 MB
CD-ROM
24x IDE CD-ROM Drive (slim line)
Hard Drives
Two 1
″
36.4-GB Ultra3 10K rpm hot plug drives (contain operating system in a
RAID 1 configuration)
Maximum Internal Storage
78.2 GB (2 x 36.4-GB Wide Ultra3 1
″
drives)
Ex tern al S tor age
Minimum External Storage
MSA1000 (4 (for non-clustered) to 6 (for clustered) x 72-GB drives depending on
model)
Int er fa ce s
Parallel
Not supported
Serial
1
NOTE
: You can configure a second serial device to your NAS B3000 server by
installing the auxiliary serial connector that ships with the server. The
auxiliary connector attaches to a serial port B on the peripheral board
and exits the rear of the server through the auxiliary serial knockout
located directly above the dual power feeds.
Pointing Device (Mouse)
1
Graphics
Available through the “Remote Insight Board” only
Hot Plug Keyboard
1
External Wide Ultra2
SCSI
1