Removal and replacement procedures
Maintenance and Service Guide
4–9
5. Remove the 2 hard drive spacers
1
that secure the hard drive in the hard drive bay.
6. Grasp the Mylar tab
2
on the hard drive and slide the hard drive
3
to the right.
7. Remove the hard drive
4
from the hard drive bay.
8. If it is necessary to replace the hard drive bracket, follow these steps:
a. Remove the two Phillips PM3.0×4.0 screws
1
from each side of the hard drive.
b. Lift the bracket
2
straight up to remove it from the hard drive.
Reverse this procedure to reassemble and install the hard drive.
