Installing Hardware Options
4-15
Compaq Confidential – Need to Know Required
Writer:
Rick Chew
Project:
Compaq ProLiant 8500 Servers Setup and Installation Guide
Comments:
Part Number:
323333-001
File Name:
e-ch4 Installing Hardware.doc
Last Saved On:
5/5/99 10:11 AM
3.
Remove the memory board by rotating the ejectors outward
1
and
pulling the board out
2
.
4.
Place the memory expansion board, components facing up, on a flat
surface.
1
1
2
Figure 4-14. Removing the memory board
NOTE:
The memory board is part of the system interconnect scheme and must be seated
properly for server start up. For more information see the “System Interconnect Status
Indicators” section in Chapter 3, “Server Operation.”
CAUTION:
The ejectors prevent the memory expansion board from lying
completely flat. Inserting a DIMM without counter pressure applied behind the
socket to the back of the expansion board can cause the memory expansion
board to flex and could result in damage. Always support the memory expansion
board or apply counter pressure while inserting a DIMM.
5.
Open the DIMM socket latches
1
as shown in the following figure.
6.
Align the key slot on the bottom edge of each DIMM with the tab in the
DIMM socket.
