Completing the Server Installation
If you chose to install and start all the services automatically, the server installation has been completed.
The server will now be running Image Manager, PXE server and the FLEXnet license server, waiting
for the first client to connect. However, the clients will need a virtual disk from which to boot. The creation
of this virtual disk is covered in the chapter
Initial Client Configuration
.
If you chose to do any of the steps manually (for example, if you have an existing FLEXnet server), you
will need to complete this section before continuing with this guide.
The following procedure assumes you have already installed the
Server
components of the HP Image
Manager using the Installer Wizard described earlier.
1.
Navigate to the directory containing the installed HP Image Manager software.
●
If you performed a
Server Installation
the default destination is
C:\Program Files\HP Image
Manager
●
If you performed a
Decompress All
operation, you must navigate to the directory to which
you decompressed the software.
Once you have located this directory, the Windows server components are stored in the
Server
subdirectory; the Linux server components are stored in the
Server\Linux
subdirectory.
2.
If required, copy the relevant NVDD file for the operating system you are using into a directory in
the server partition where the virtual hard disks will be stored.
3.
If required, copy the files
SmallDisk.vol
and
nvdd.smalldisk.vol.conf
from the Server directory
to the directory containing the NVDD server module.
This completes the HP Image Manager server initial configuration. You can test that the NVDD server
module is installed correctly by navigating to the directory containing NVDD then typing one of the
following at the command prompt to launch it:
Windows system:
nvdd -c nvdd.smalldisk.vol.conf
Linux system:
./nvdd -c nvdd.smalldisk.vol.conf
You should see various messages similar to that shown in the illustration below.
To stop the NVDD server module, press the keys
Ctrl
+
C
.
You will then to need to install the Image Manager server service as a service or daemon on the operating
system you are using. For Windows, HP provides the
srvcloadersetup.exe
program in the
Server
directory, which can assist with installing the Image Manager server as a service.
18
Chapter 2 Installing Image Manager Components
Summary of Contents for st5548 - Thin Client
