Rear View
Front View
1
Front panel
2
Power indicator
3
Cassette access door
4
Liquid Crystal Display
5
Control buttons
6
Error LED
7
Ventilation Holes
1
Power supply connector
2
Power switch
3
Fan unit
4
Transport screw positions
5
SCSI connector 1
6
LAN connector
7
SCSI connector 2
IMPORTANT:
The Orange Transport Screw must be moved to the
Operation
position before operating the AutoLoader. The AutoLoader will not function
properly with the Transport Screw in the
Shipping
position.
1. Install an inner rail to the side of the AutoLoader using the provided screws,
as shown.
NOTE:
The mounting holes will only line up when the rails are properly
positioned. If the rails do not line up flip the rail over 180 degrees
.
2. Install a mounting bracket to the front of the AutoLoader using the provided
screws, as shown.
3. Repeat step one and two on the other side of the AutoLoader.
Complete the following steps to prepare the AutoLoader for rackmounting.
Preparing the AutoLoader
1
1. Mark the center of a 1U mounting location on both sides of the front
mounting rails.
2. Repeat step one on the rear mounting rails.
Use the template that shipped with the library to mark the location of the
mounting hardware on the mounting rails of the rack.
Measuring with the Template
2
1
2
3
4
5
6
7
1
2
3
4
5
6
7
