PM1323
/
4-6 ENGINE CONTROLS
1- IGNITION SWITCH
. Set this switch in
START
position for
start engine. Placein
OFF
position for Stop Engine.
2-
SPEED CONTROL
In RUN/IDLE position, engine runs at idle speed at
no load, and change
automatically to speed
operation ( 3700 RPM ) just when begin to weld or connect
a load in auxiliary power.
In RUN position, the engine runs at 3700 RPM, is
recommended us e this position when use auxiliary power
and constant voltage option either.
Always the Unit is not Use Place the Switch in the OFF
position, to preven discharging the battery.
4- CHOKE
. Choke control is provided for varying the fuel-air
mixture to the engine.
Set ignition switch in Start position.
Pull totally choke BEFORE START engine.
Press the
Push Button To Activate the Start Engine; Left Press when
4-5 AMPERAGE / VOLTAGE FINE CONTROL
1.- FINE CONTROL (AMPERAGE/ VOLTAGE)
Use control to set weld amperage or v oltage within the range
selected by the coarse range selector.
The scale is a percentage of the range selected non an actual
amperage or v oltage v alue.
Control may be adjusted while welding.
NOTE: SET AT 7-10 FOR POW ER W HILE W ELDING
/
1
2
SET AT 10 FOR MAX. GENERATOR POW ER
9
