PM1323
1
2
4-7 MIG WELDING OUTPUTS AND SETTINGS CONTROLS
1.- WELD PROCESS.
Set this selector in REVERSE POLARITY.
2.- COARSE RANGE.
Set this selector in HIGH RANGE or LOW RANGE according to your needs.
3.- CIRCUIT BREAKER CB6.
Protects to 24 Vac winding agains ov erloads on receptacle RC4.
4- RECEPTACLE RMT 14 (RC4)
Insert the conector of the wire f eeder, and tighten firmly. this reeceptacle
supply 24 Vac to wire feeder.
5.- WELD OUTPUTS.
Connect work clamp to W ORK terminal. Connect the wire feeder to MIG term inal.
5
IMPORTANT When wire feeder use is required, set engin e control on position (See- sec 4)
3
4
10
