4-1 LOCATION OF CONTROLS IN WELDING POWER SOURCE.
8
CAUTION
SECTION - 4 OPERATION
SEE SAFETY SIGNALS AT THE
BEGINING THIS MANUAL
Figure 4-1 Controls
1-
''POWER''
Switch.
ON - OFF
2-
''V CONTROL''
Switch.
PANEL - REMOTE.
3-
''OUTPUT''
Switch.
ON-REMOTE.
4-
''VOLTAGE ADJUSTMENT''
Control.
Turn clockwise to increase voltage.
5- Digital voltmeter.
6- Digital ammeter.
Figure 4-2. " POW ER ''
* POW ER switch
Turn on and turn off the power source.
ON
OFF
POWER
ON
REMOTE
OUTPUT
* OUTPUT switch
PANEL position for front panel control of output, weld output terminals are
energized.
REMOTE position for remote control of output, needed connect remote device
in Remote - 14 receptacle.
Figure 4-3. ''OUTPUT''
H ECHO
E N
M E X ICO
1
2
3
5
4
6
4-2 ''POWER'' SWITCH
4-3 ''OUTPUT'' SWITCH
* Voltage CONTROL switch
PANEL position for front voltage control.
REMOTE position for remote voltage control, needed connect
remote device in Remote-14 receptacle.
Figure 4-4. ''
V
CONTROL''
4-4 ''V CONTROL'' SWITCH
PANEL
REMOTE
V
CONTROL
