Check torch according gun torch owner´s manual. Replace damage parts.
Readjust drive rolls pressure.
Check and replace contact tip if necessary.
Check and remove any obstruction in wire feeder mechanism.
Be sure plug trigger connector is in receptacle for gun trigger.
Consult your dealer or Service Center to review the connections and when
necessary the electronic board in welding power source.
Consult your dealer or Service Center to review, mechanism, connections and
when necessary the electronic board in wire feeder.
TABLE 5-2. TROUBLE WITH MIG GUN AND WIRE FEEDER.
Wire feed but stops during
welding process
REMEDY
TROUBLE
REMEDY
PROBLEM
Be sure jumper links is in position according voltage available at site..
Adjust the control voltage according application.
Low weld output current.
No weld output, wire feed is
working.
Consult your dealer or Service Center to review the connections and when
necessary the electronic board.
Connect the work clamp for assure electric contact
13
