Air Compressor BOX 3in1
e
2
item 07 205
Digital compressor in compact design with 12V supply. Long power cord with plug for 12V car lighter
socket.
The compressor is suitable for inflating vehicle, motorcycle, or bicycle tyres. Additional adapters for
various use (ball, mattress, swimming pool, etc.) are included.
The compressor is equipped with the Auto Stop function, which inflates the tire to a pre-set pressure,
then automatically switches off. The built-in detachable pressure gauge measures in several different
units.
Built-in 9x LED torch for illumination of the workspace.
This manual must be thoroughly studied before use, in order to ensure safe and proper use of
device.
INSTRUCTIONS FOR USE
Air compressor
!
Connect power cord to the 12V car lighter socket.
!
Atach the compressor hose to the valve.
!
Press the ON button of the compressor, the gauge will show the tire pressure.
!
Use the up and down arrows to set the desired pressure.
!
Turn on the compressor switch.
!
Once the required pressure has been reached, the compressor will automatically shut down.
Tire pressure gauge
!
The compressor body is fitted with a pressure gauge that can be removed and used to measure
tire pressure.
!
Open the storage compartment cover on the compressor.
!
Release the pressure gauge clip and remove it.
!
Use the ON button to turn on the gauge and use it to measure tire pressure.
!
Press the ON key again to clear the measured values.
!
To change pressure units of the gauge, long press the ON button.
Flashlight
!
The LED flashlight on the compressor side serves for illumination of the workspace.
!
After switching on (connecting the plug to the 12V car cigarette lighter socket), light turns on
automatically.
!
Turns off automatically, after disconnecting the power supply.
ATTENTION
Never leave compressor switched on for more than 20 minutes - risk of overheating.
Inflating on higher pressures, may take more time (more air pressure is required).
The compressor is equipped with a fuse, that is built into the car lighter plug. Replace it by unscrewing
the front of the plug.
