16
Chapter 5 - Command Line Management
interface. You can then do the following:
1.
Set the host’s IP address to 198.41.12.2, with a Class C subnet
mask (255.255.255.0) and then Telnet to 198.41.12.1.
2.
Enter the default password letmein at the password prompt. The
command line interface prompt will appear on the screen.
3.
Use the configure command and set the IPAddress, SubnetMask,
and IPBroadcast keywords in the IP Ethernet 0 section.
4.
Use the save command to save the changes to the device’s Flash
ROM.
5.
Change the host’s configuration back to its original settings.
See the next section (Setting Up Telnet Operation) for information on
setting the router to allow Telnet access from hosts on its network.
Setting Up Telnet Operation
Telnet is a remote terminal communications protocol based on TCP/IP.
With Telnet you can log into and manage the MicroRouter 1200i from
anywhere on your IP internetwork, including across the Internet if your
security setup allows it. To manage the router with Telnet, you must:
1.
Run Telnet client software on your local computer, which will com-
municate with the Telnet server built into the MicroRouter 1200i.
2.
You must also set some basic IP parameters in the router. The
required parameters for Telnet access to an interface are the IP
address, IP subnet mask, and IP broadcast address. There are sev-
eral ways to set them.
•
You may set them using text-based configuration either
out-of-band via the Console interface or in-band via a recon-
figured IP host. Instructions for setting up these two methods
were given earlier in this chapter. Once you have set up the
command line interface, do the following:
A. Use the configure command and set the IPAddress,
SubnetMask, and IPBroadcast keywords in the IP
Ethernet 0 section.
B. Use the save command to save the changes to the device’s
Flash ROM.
•
You may also use CompatiView from a reconfigured IP host (if
using the IP transport protocol), or anywhere on your network
(if using the IPX transport protocol). Instructions for these
