Chapter 4 - LED Patterns
12
Chapter 4 - LED Patterns
Some of the LEDs on the front of the VSR multigigabit switching router serve dual functions.
In addition to indicating certain router-wide operating conditions, they may also display port-
specific information.
v
Note
: Any continuous flashing pattern not noted in this chapter may be caused by a hard-
ware failure. Please call Compatible Systems Technical Support if your router shows a hard-
ware failure.
Router LED Patterns
The following LEDs and light patterns provide information about the VSR’s physical state and
operating conditions.
Over Temp
The router is above the proper operating temperature. The filter needs changing. See the
appropriate VSR chassis section of the manual for instructions.
Sys Ready
The router booted properly without detecting any failures.
General Indicators
Octal V.35-10/100 RIOP LED Patterns
The following LEDs and light patterns provide information about the Octal V.35-10/100 RIOP
interfaces.
Ethernet Traffic Indicators
Scan from 1 to 3: Ethernet transmit packet
Scan from 5 to 3: Ethernet receive packet
V.35 Traffic Indicators
TX: WAN transmit packet
RX: WAN receive packet
Ethernet Connection Indicators
Link: The Link light indicates that there is a good connection to the hub.
Activity: The Activity light indicates that there is activity across the link.
100: The 100 light indicates that the interface is operating at 100 Mbps.
Ethernet Lights
V.35 Lights
Indication
5 flashing
1 flashing
Router stacks starting up.
3&4 flashing
2&3 flashing
No OS loaded. Running from ROM.
1&4 flashing
2&5 flashing
Erasing OS in Flash ROM.
5 flashing
1,2&3 flashing
Erasing config in Flash ROM.
1 - 5 scanning
5 - 1 scanning
Flash ROM erase due to switch setting five or six
is complete. Set switch to zero and cycle power.
