Page | 7
l g into a gro nded o tlet.
o not remo e rote e gro nd.
o not se an ada ter.
o not se an e tension ord.
ail re to follow these
instr ons an res lt in death
re or ele tri al sho .
GROUNDING REQUIREMENTS
Improper connection of the grounding conductor appurtenant to the Compax One
™
may result in a
risk of electric shock. If you are in doubt of whether the appliance is properly grounded, check with a qualified electrician or
a service representative.
▪
Electrical ground is
REQUIRED
on the Compax One
™
.
▪
DO NOT
ground to a gas pipe.
▪
DO NOT
change the plug on the power supply cable. If it does not fit the outlet, have a suited outlet installed by a qualified
electrician.
▪
DO NOT
have a fuse in the neutral or grounding circuit as this may cause an electric shock.
▪
DO NOT
use an extension cord or adapter with the Compax One
™
.
Failure to follow these instructions can result in death or serious injury.
GROUNDING INSTRUCTIONS
The Compax One
™
is for use on a nominal 220-240 V mains circuit and is equipped with a power supply cable consisting of three
conductors for line, neutral and ground. The Schuko plug (CEE 7/4) features two pins for the line and neutral contacts, and two
flat contact areas for protective ground. The Schuko plug should always be used in
the proper grounding-type receptacle, Schuko socket (CEE 7/3).
If a Schuko type wall receptacle is not available, it is the responsibility and
obligation of the customer to have it installed by a qualified electrician. A direct
connection of the power cable to the nearest properly grounded branch circuit may
serve as an alternative to the general plug and socket, if installed by a qualified
electrician
.
The green (or green and yellow) coloured conductor in the cord is the
grounding wire. Never connect the grounding wire to a live terminal.
UNBOXING THE COMPAX ONE
™
Move the Compax One
™ lose to the installation lo ation.
Proper unboxing should leave the Compax One
™
standing upright on a support structure
being part of the packaging.
Remove all protective packaging materials before use.
Check that all necessary parts are supplied.
IMPORTANT:
Use parts of the packaging carton, or similar, as protection between the floor
and the Compax One
™
in order to prevent any damage. Do not slide the appliance across
the floor as this may cause damage to the floor and/or the appliance.
MEASURING AND DRILLING HOLES
Tape the installation template, included in the packaging, to the assigned wall area.
Mark four spots on the wall according to the installation template.
Ensure that the marks are correctly placed and levelled before proceeding.
Use a drilling machine with a drill bit of size Ø6 mm and drill a hole for each marked spot
on the wall.
