2-2 Chapter 2: Installing the Adapter
p
Using BNC (thin coaxial) cable:
Using thin coaxial cable: Connect a T-connector
to the BNC connector on the media coupler.
Attach both ends of the T-connector to thin
coaxial cables. If the card is at the end of the
network segment, install a 50-ohm terminator at
the open end of the T-connector. Do this
carefully to prevent accidental shorts which may
disrupt network operation.
5.
Power ON the PC.
Hardware installation is now complete. Switch
ON the PC. The Compex LinkPort PCMCIA
Ethernet Card receives its power from the PC.
Warning: To avoid accidents, do not connect or
disconnect cables, or perform installation or
maintenance of the card during an electrical
storm.
Removing the Card:
Procedure:
To remove the Compex LinkPort PCMCIA Ethernet
Card from the PC, do as follows:
1.
Power OFF the machine.
2.
Remove from the coupler the UTP cable from the
RJ-45 socket; or if coaxial cable, the T-connector
from the BNC socket.
Summary of Contents for LinkPort ENET-B
