12
Compex WavePort WL11
English
The first three fields show your wireless LAN card state.
Link status – indicates link accessibility. There are several values, that can
be shown in the this part of the widow:
11.
Associated – BSSID=… - normal flow of operation in Infrastructure
mode. The PC is connected to access point. BASSID is shown in the
form of HEX digits. Networking is available.
12.
No status… - the manager is retrieving information from the driver. If
this text box value stays more than several seconds, it means that there
are no access points or other workstation (if communicating in AdHoc
mode), or that the WL11 LAN card is plugged out the PC.
13.
Scanning for access point - driver scan wireless network searching
for available access point in Infrastructure mode.
14.
Disabled or disconnected – If this text box value stays more than
several seconds, it means that there are no access point or other
workstations (if communicating in Pseudo BSS mode), or that the
WL11 LAN Card is plugged out of PC.
15.
Undefined – means critical driver error. This error is usually caused by
hardware misconfiguration (for example the card with similar chipset
inserted in PC card tray, but not fully compatible with COMPEX).
•
Input byte/sec – shows the incoming (received) data speed, the progress bar
below, means receiver load.
•
Output byte/sec – shows the outgoing (sent) data speed, the progress bar
below, show transmitter load.
•
Signal strength: bar shows signal strength level. The higher blue bar is, the
more powerful is radio signal received by WL11. This indicator helps to
find the most comfortable antenna/workstation position for quality network
operation.
•
Link quality: the measured signal level gives the overall Link Quality and
Connection Status.
Summary of Contents for WAVEPORT WL11
Page 55: ...NOTES ...