14
Compex WavePort WL11
English
•
RFC1042 where the DIX Ethernet frames are converted using SNAP
header based on RFC1042. This mode will also convert any RFC1042
SNAP header frames to DIX Ethernet frames before transmission to the
Ethernet interface.
•
802.1h where the DIX Ethernet frames are tunneled using a full
selective translation table. This mode does not convert RFC1042 SNAP
header frames to DIX Ethernet before transmission to the Ethernet
interface.
It is required to select encapsulation mode corresponding to the one your
access point or other workstations use. If the encapsulation mode is
incorrect, the PC will join to access point or will be seen by other
workstations, but network operation will not work.
♦
Channel – show radio channel number for networking. Only Access Point
and Ad Hoc nodes can create a BSS therefore this parameters is not active if
Mode is Infrastructure. Infrastructure Client nodes will always go the same
channel as their AP. Please see the table for the requirements of different
countries and the channel frequency.
♦
TX Rate: The transmission rate at which the data packets are transmitted
by the client or AP. You can see this to Auto select or 2Mbps, Fixed 1Mbps,
Fixed 2Mbps, Fixed 5.5Mbps, Fixed 11 or Full Auto (1 to 11Mbps).
Important : You must know the TX Rate that your AP can support.
Failure to which may cause the undesired results.
Summary of Contents for WAVEPORT WL11
Page 55: ...NOTES ...