Complete Control MRZ-260 - AUTRE, Installation Manual

MRZ-260 B

ASE

S

TATION

Page 14

Frequently Asked Questions

Can I use flasher/emitters that I have already installed in the sys-
tem to connect to the MRZ-260?

Yes, the flashers are compatible if they use 3.5mm mono mini plugs with
the same polarity (Tip is data, sleeve is ground). It is important to notate 
the RFTX-1 shared port utilizes a sleeved emitter for long term use. 

I’m getting inconsistent operation regardless of flasher level or
position.

Some components are easily overloaded with IR from nearby flashers.
Prevent IR from affecting the problem component from other flashers or the
front panel blaster by setting the device to a specific IR Line Output instead
of ALL, then adjust the Line Output.

I am unable to control my URC Lighting Dimmer/Switch with the
MRZ-260. Now what?

Make sure the RF switch on the RFTX-1 is set to the correct frequency for
the URC Dimmer or Switch.  URC Lighting Models MRFA is 418MHz and
MRFB is 433MHz.

Specifications

Power Supply: 9V 300mA
2 Variable IR Outputs: 3.5mm Mono Mini Jack
2 Fixed IR Outputs (1 combination RFTX-1 Port): 3.5 mm Mono
Mini Jack (Use sleeved emitter only for RFTX-1 output)
RF Frequency: 2.4GHz
Size: 5”x3.25”x1”