equipment (e.g. blinking of a lamp).
If the MAINS-IMPEDANCE Zmax < 0.323 OHM, such disturbances are not expected.
(In case of need, you may contact your local supply authority for further information).
Note !
This cordless tool is restricted to using on wood, wood like products, leather and material of paper. Any other material is forbidden.
Caution !
Not suitable for stapling or nailing into concrete, masonry, bricks or steel.
Do not fire if nails are jammed, as this will cause damage to the driver blade.
The supply voltage must correspond to the voltage shown on the tacker.
The electrical supply must be single-phase and in accordance with the standards in force. Never connect the tacker to a three-phase supply
or to motor-powered generators.
Keep the cable away from sharp edges in order to avoid a short circuit and fire risk.
Do not exceed the maximum average firing rate. You are recommended to leave it to cool down, if the tacker overheats or driving times
stipulated.
Do not rest a hand on the trigger during loading or as a habit.
Extension cord may impair the driving force if too long or too thin, by deteriorated plugs.
Tacker safety warnings
Always assume that the tool contains fasteners.
Careless handling of the tacker can result in unexpected firing of fasteners and personal
injury.
Do not point the tool towards yourself or anyone nearby.
Unexpected triggering will discharge the fastener causing an injury.
Do not actuate the tool unless the tool is placed firmly against the workpiece.
If the tool is not in contact with the workpiece, the fastener
may be deflected away from your target.
Disconnect the tool from the power source when the fastener jams in the tool.
While removing a jammed fastener, the tacker may be
accidentally activated if it is plugged in.
Do not use this tacker for fastening electrical cables.
It is not designed for electric cable installation and may damage the insulation of electric
cables thereby causing electric shock or fire hazards.
Read this manual and understand all safety instructions before operation the tool. If you have any questions, please
contact our authorized representatives.
Employers and users are responsible for ensuring user or anyone near the tool wear this safety protection.
Protect your eyes and ears. Wear z87.1 safety glasses with side shields.
Staples or nails leaving the nose are dangerous and may cause injuries. Never point tool at yourself or at any other person.
Do not place your hand or any part of your body in the fastener discharge area of the tool when connecting or disconnecting air
supply.
Carry the tacker at workplace using only the hand grip and never with the trigger actuated. Never carry the tacker by cable or pull
the cable to move.
List of fasteners for E54/16
：
Crown
Shank
Shank
Length
Gauge
Thickness
Width
B.W.G.
4.4 mm
0.5 mm
1.25 mm
Staple 8-16mm
20
