background image

 

Disclaimer:  

NOTICE

This device complies with Part 15 of the FCC Rules and with Industry Canada licence-exempt RSS 

standard(s). Operation is subject to the following two conditions:  

1. this device may not cause harmful interference, and 2. this device must accept any interference received, including 

interference that may cause undesired operation.  

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio 

exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:  

1. l'appareil ne doit pas produire de brouillage, et 2. l'appareil doit accepter tout brouillage radioélectrique 

subi, même si le brouillage est susceptible d'en  

compromettre le fonctionnement.  

NOTICE

Changes or modifications made to this equipment not expressly approved by Compology may void the 

FCC authorization to operate this equipment.  

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of 

the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential 

installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in 

accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee 

that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or 

television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct 

the interference by one or more of the following measures: 

—Reorient or relocate the receiving antenna. 

—Increase the separation between the equipment and receiver. 

—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 

—Consult the dealer or an experienced radio/TV technician for help. 

As in FCC / ISED RSS-102 standards, to comply with FCC RF exposure requirements for mobile transmitting devices, this 

device shall be installed to provide a separation distance of 20cm (~8 inches) or more from all persons  

And the transmitters on this device do not transmit simultaneously.  

Summary of Contents for SkyCamera

Page 1: ... 3 16 drill bit 1 3 4 44mm hole saw Bracket Placement Spacer PN 190 0035 Riveter rated to be able to pop 3 16 stainless steel rivets 5 32 Pin in Hex Security Bit Ladder please follow all OSHA ladder guidelines Recommended Safety gloves and protective eyewear Camera placement Camera should be installed on the exterior of the container left side as you look at the door end The top of the bracket sho...

Page 2: ...acket and taking care to keep the bracket vertically oriented press the bracket firmly against the trailer to set the tape 4 Using the 3 16 drill bit drill out the 8 rivet holes 5 Using the rivet tool set the 8 rivets in the holes 6 CRITICAL Before installing the camera in the bracket write down record the device ID This is located on the front transparent housing just above the camera turret The ...

Page 3: ...wipe to the right of the LED status indicator The magnet should be held in place for 3 seconds at which point the LED should rapidly flash yellow orange Once rebooted the device will blink blue for 20 seconds at which point it will either blink green indicating the hardware checks are okay or red indicating a hardware fault If green try BLE pairing a second time If red replace it with a new camera...

Page 4: ... limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If th...

Reviews: