Initial Setup & Basic Operations
Compress iUV600s Series User Guide
55
5.6.6
Loading Media for Printing
1.
Pull the platen tray forwards to allow easy access to the platen as shown.
Warning, do not
pull the platen abruptly, optimal movement should be no more than 6cm per second
If you are using paper for test printing purposes, uses paper masking tape to hold the edges of the
paper down. The use of a silicone sticky mat or vacuum bed is highly recommended, contact your
product representative for more information on these optional components.
As you are now ready to print your first test print or nozzle print, please review the steps undertaken
to get to this point, if you have doubts, consult with your product representative.
2.
Place your print media onto the bed of the machine. This can either be flat sign media in
sheet form or a precut template populated with object that require to be decorated.
3.
Pay close attention to the highest point of the media placed in the machine. Ideally, the
media should lay as flat and as even as possible.
CAUTION
TIP
Please Note:
Bed/media 0/0 point is front/right
edge of the moving bed.
Summary of Contents for IUV600S SERIES
