16
Step 4:
For LNB/Transponders settings, you will see settings for satellites and transponders.
(1). Find and click on required satellite on list. Fill appropriate LOF1, LOF2, SW values.
Please read instruction of LNB convertor you use.
Don’t forget to click on “Apply”
button when you finish setup satellite LNB parameters.
(2.) Click on button
“Sel All” (right side of window) to select all transponders or while
holding
“Ctrl” key click sequentially on every transponder you want to scan. Click on
button
“-=SCAN=-“ to start scanning process.
Note:
If you see universal (dual-band) Ku LNBF then usual parameters are:
LOF1=10600000, LOF2=9750000, SW=11700000. If you use DiSEqC switch
or motor then click on DiSEqC button and choose appropriate LNB input port.
Summary of Contents for VideoMate S700
Page 21: ...20 Display You can set up display option Interface You can choose the language by this page...
Page 25: ...24 Volume Audio Setting Audio options Subtitles Setting Subtitle language you prefer...
Page 29: ...28 Remote Control The outlook of remote control and button definitions has shown as below...
