Interfaces and Connectors
Revised May 2011
SB-A510 Rev 1.1
19
4.9
LVDS Header (P9)
LVDS output signals are routed from the LVDS Transmitter IC to the onboard 100mil header (P9).
For additional details, please refer to section
3.3
of this document.
In order to use the LVDS interface, CM-A510 display system must be set to RGB 888 operation
mode.
NOTE: The P9 connector does not provide power for the LVDS LCD panel and its backlight.
An external power source is required.
Table 22 P9 connector pinout
Pin
Signal Name
Pin
Signal Name
1
LVDS_NE0
6
GND
2
LVDS_NE1
7
LVDS_NE2
3
LVDS_PE0
8
LVDS_NEC
4
LVDS_PE1
9
LVDS_PE2
5
GND
10
LVDS_PEC
4.10
Touch Screen Header (P12)
The touch screen (P12) header of the SB-A510 allows evaluating any resistive touch panel with the
touch panel interface provided by the CM-A510. Please refer to the CM-A510 reference guide for
additional details on the touch-screen interface.
NOTE: The P12 connector does not provide power to the touch panel.
Table 23 P12 connector pinout
Pin
Signal Name
Pin
Signal Name
1
GND
6
NC
2
TS_X-
7
TS_Y+
3
GND
8
TS_Y-
4
TS_X+
9
GND
5
NC
10
GND
Summary of Contents for SBC-A510
Page 1: ...SB A510 Reference Guide ...
