Hayetsira St. 17, Yokneam, Israel
Tel: +972-48-290-168 | Fax: +972-48-325-251 | www.fit-iot.com
www.fit-iot.com
Page 12 of 19
Tensor-I22 owner’s manual
M.2 cooling plate and NVMe/SATA
The M.2 cooling plate has several purposes:
• Allow installation of multiple form factor M.2 devices
• Provide cooling to M.2 devices
M.2 Key-M accepts SATA of NVME modules, 2230, 2242, 2260 or 2280.
M.2 Key-B accepts SATA M.2 modules or modems, with lengths of 30mm, 42mm,
52mm or 60mm and widths 22mm or 30mm
All modules have to be fastened to the M.2 cooling plate.
To install NVMe/SSD onto M.2 cooling plate
1.
The red spacer is already assembled on the plate. Move the red M.2 spacer
according to the length of the M.2 NVMe/SSD as depicted below. Insert M.2
fastening screw but do not tighten!
2.
Place edge of M.2 NVMe/SSD against the fastening screw
a.
Press the NVMe/SSD firmly until its connector edge is seated between the
alignment pins and rests on fastening screw.
Once positioned correctly the connector edge should stick out above the
edge of the M.2 cooling plate.
3.
Tighten the spacer screws
