Hayetsira St. 17, Yokneam, Israel
Tel: +972-48-290-168 | Fax: +972-48-325-251 | www.fit-iot.com
www.fit-iot.com
Page 2 of 19
Tensor-I22 owner’s manual
Safety instructions
Use the following safety guidelines to help protect your computer from potential damage and to help to ensure your
personal safety. Unless otherwise noted, each procedure included in this document assumes that you have read the safety
information that shipped with your computer
WARNING: Disconnect all power sources before opening the
computer cover or panels. After you finish working inside
the computer, replace all covers, panels, and screws before
connecting to the power source.
CAUTION: Some repairs may only be done by a certified
service technician. You should only perform troubleshooting
and simple repairs as authorized in your product
documentation, or as directed by the online or telephone
service and support team. Damage due to servicing, that is
not authorized by Compulab, is not covered by your warranty.
Read and follow the safety instructions that came with the
product.
CAUTION: To avoid electrostatic discharge and prevent internal
components damage from electrostatic discharge when touching
computer or its parts, ground yourself by using a wrist
grounding strap or by periodically touching an unpainted metal
surface, such as a connector on the back of the computer.
CAUTION: Handle components and cards with care. Do not touch
the components or contacts on a card. Hold a card by its edges
or by its metal mounting bracket. Hold a component such as a
processor by its edges, not by its pins.
CAUTION: When you disconnect a cable, pull on its connector
or on its pull-tab, not on the cable itself. Some cables have
connectors with locking tabs; if you are disconnecting this
type of cable, press in on the locking tabs before you
disconnect the cable. As you pull connectors apart, keep them
evenly aligned to avoid bending any connector pins. Also,
before you connect a cable, ensure that both connectors are
correctly oriented and aligned.
