108
Compulite
Chapter 6
The maximum dimmer output is reset to 100%.
4
Tap
OK
.
To create an inhibit submaster
Example: Set playback 1 to submaster selected fixtures. Example: A playback is configured to
submaster channels 1 10. A scene loaded to a playback contains channels 1 20 @ 80%.
Setting the slider for the submaster scene at 50% results in channels 1 10 @ 40% and chan-
nels 11 20 @80%.
1
Select fixtures.
2
Press
SUBMASTER
.
3
Press the
SELECT
key for playback 1.
4
The slider level for playback 1 inhibits the output for the selected fixtures.
About the crossfader
QLists are played back on the playbacks or on the crossfader. When a QList is loaded on the cross-
fader, cue 0 is the active cue and the first cue is the incoming cue. You can sequence through the
cues or preload a cue out of sequence. Cues fade according to the fade times set for each cue. On-
the-fly, you can fade to a cue using system time, ignoring the cue time.
Figure 27: The crossfader for QList playback
No.
Controls
No.
Controls
1
SELECT
key to load the device
5
Next or current cue display
2
Next or current cue display
6
GO
- initiate a fade to the next cue
3
HOLD
- pause the fade
7
Master incoming values
4
BACK
- fade back to previous cue
8
Master outgoing values
Summary of Contents for Dlite
