Remote Coding / Programming Routine(s)
Remote Coding / Programming Routine(s)
IMPORTANT:
Every CompuStar Pro remote must be coded to the system prior to performing any
operations. All remotes must be coded at the same time.
IMPORTANT:
Every CompuStar Pro remote must be coded to the system prior to performing any
operations. All remotes must be coded at the same time.
Programming P2BSHLEDR
Programming P2BSHLEDR
STEP 1:
Activate Valet/Programming mode by manually turning the ignition key
on
and
off
(between the
Acc & On positions) five times within 7 seconds. The vehicle’s parking lights will flash once with the
successful completion of this step.
STEP 2:
Within a 3 second period after cycling the ignition for the 5
th
time, pressing the single button
once for 0.5 seconds. The parking lights will flash once to confirm the transmitter has been coded.
Exiting Programming:
Programming is a timed sequence. The
parking lights will flash twice signaling the end of programming mode.
Programming Multiple Remotes:
After the confirmation flash given in
step 2, code additional remotes by pressing the single button
on
remote. The parking lights will flash once confirming each additional
remote. All systems can recognize up to three remotes.
Remote Start Error Diagnostic
If the remote start fails to start the vehicle, the parking lights will flash three times immediately. Following
those three flashes the parking lights will flash again corresponding to the error table.
Number of
Parking Light
Flashes
Remote Start Error
1 Motor
running
2
Key in ignition on position
3
Door open (manual transmission only)
4 Trunk
open
5
Foot brake on
6 Hood
open
7
Reservation off (manual transmission only)
8
Tach or voltage sensing failure
We recommend that you do not attempt any repairs on your remote starter. Contact your dealer or call us
directly.
8
