D
ATA
M
AXX
Figure 3: Channel Properties allow you to change the name and type of every sensor
L
IGHTS
& R
ECORD
The
D
ATA
M
AXX
system includes customizable lights and log file recording. The Main module is
equipped with two light outputs that produce a 12V signal and the LCD has a yellow and red light built
in. You can set any sensor to trigger any of these lights to turn on when it gets below or above a certain
value. You can also use any sensor value to automatically trigger recording, such as drive shaft
movement.
To change, open the Calibration/Configuration window, and click on the “configure” button for the
channel you would like to change. Now click on the “ Record” tab to adjust.
O
VERLAYING
R
UNS
To overlay multiple runs, simply open a log file, and when that graph is displayed, open another log file
and they will sit on top of each other. You can overlay multiple runs, however you cannot remove an
individual run from the overlay and closing the run will close all of the overlaid files.
C
USTOMIZING
V
IEWS
When looking at your log file's you may find that you prefer to see certain channels in the same graph
or prefer a certain zone section to be larger or smaller. You can accomplish this through the software
with ease.
Copyright c 2008 Computech Systems Inc. 37