Call Free 1.800.848.1633 • Fax Free 1.800.447.2923
Web: GoHCL.com • Email: hcl@GoHCL.com
INSTRUCTIONS FOR
Keyless Entry Digital Lock, Audit Trail, Vertical Mount (#19691)
© Health Care Logistics, Inc. 2017
, Keyless Locking 3
Packaged Components
cont.
Contents – Self-Lock Version:
•
Self-locking
Lock assembly featuring
SlamCAM
•
(2) AAA alkaline batteries
•
SlamCAM spacer discs
•
Mounting hardware
Powering Up and Battery Installation
CompX
®
is shipped with two installed AAA batteries. While
features a low battery indicator, scheduled battery replacement is
recommended. Mixing batteries of different chemistries could damage the
resulting in lock failure.
To power up
, pull the red tag. The lock is now ready for use.
Note: In the event the batteries should die, they can be replaced via the external
battery compartment.
If equipped, a tamper resistant T-15 pin-in Torx
®
(6-lobe) bit or driver (not
included) will be required to remove the battery cover.
Restoring Factory Codes
The RegulatoR -AT features a factory reset code which will restore the default
1-2-3-4 & 1-2-3-4-5 codes. The
was shipped with reset stickers;
one attached to the back of the
and an extra sticker that should
be kept in a safe and secure location for future reference if needed.
To restore the factory default codes, type the Factory Reset Code assigned to the
and press and hold
ENTER
for 3 seconds.
Care and Cleaning
To clean the
surface, apply non-acid based cleaner to a clean
cotton cloth; do not spray cleaner directly on the . Wipe down
keypad and its respective housing surfaces of excess cleaner.
