CM950W User Manual
102
www.comset.com.au
3.6.9 Static Routes
Interface:
You can choose the corresponding interface type.
Target:
The destination host IP or network.
IPv4-Netmask:
The destination IP netmask.
IPv4-Gateway:
IP address of the next hop.
Metric:
Used by the router to make routing decisions.
MTU:
Maximum transmission unit.
Table:
The route table ID. The default value is 254. Valid table ID 1-254.
Note:
The Gateway and LAN IP of this router must belong to the same network segment.
If the destination IP address is that of a host, then the Netmask must be 255.255.255.255.
If the destination IP address is an IP network segment, it must match with the Netmask.
For example, if the destination IP is 10.0.0.0, and the Netmask is 255.0.0.0.
Summary of Contents for CM950W
