Qualifier Meter
1-5
Country Set Define
From a preprogrammed list of countries, the user selects the one best suited to their area by:
(a)
placing the Qualifier meter into SETUP mode;
(b)
keying to the desired Country Set.
•
Country sets are displayed (1 to 25).
•
See the Appendix section for a listing of the available countries and their access codes.
Changing the Country Set automatically changes the channel
settings to a default set of channels for that country set.
During this sequence, the Channel Name, Units of Measure,
and the Bar Graph are suppressed from the display.
STEP KEYPRESS RESULTS
1.
Power-on the Qualifier meter in SETUP mode; this activates
Country Set Define sequence. The current Country Set code blinks,
indicating that this code can be changed.
2.
Scroll through the available country sets:
scrolls forward (1 to 25, with the standard configuration),
rolling over to the first set when the last set is passed.
scrolls backward, rolling over to the last set when the first set
is passed.
Note:
If a user channel set is installed, the country set range is 0 to 25. Set 0 is
the user channel set. See section
Feature Installation Utility
for more details.
Important:
To reinitialize a country set, scroll forward by at least one number
and then scroll back to the desired country set. The Quick-Tune keys and the
channel center frequencies (learned) are reset to default whenever the county set
is changed.
3.
The device continues to the next sequence in the SETUP mode,
Units of Measure Define
, described on the next page.
Keys remain inactive during
Country Set Define
.
Going straight to Step 3 below
without touching
leaves
current
Country Set Define
setting
unchanged and continues to the
next sequence in the SETUP mode,
Units of Measure Define
.
F6
ON/OFF
+
F1
~
F2
F6
Summary of Contents for CyberTek QUALIFIER
Page 2: ......
Page 8: ...Qualifier System iv This page intentionally left blank...
Page 47: ......
Page 48: ......
