Qualifier System
2-6
Install Transmitter Power Cable Assembly
1. Install the 15-foot Transmitter Power Cable Assembly. On one end is a factory installed
connector for the Transmitter Power Jack. The other end has bare metal contacts only.
Route the ‘contacts only’ end of the cable from the passenger or cargo compartment of
the vehicle to the Engine/Battery Compartment. Use an existing access point or drill a
7/8-inch hole between the compartments. Route the cable through the hole, and to the
battery. Install the strain relief provided to protect the cable. Seal any air leaks resulting
from the installation.
CAUTION - SAFETY NOTE
Wear eye protection when drilling or working near a vehicle battery.
When disconnecting battery cables in a vehicle:
Remove the Negative (- black)
battery terminal first. Then remove the Positive (+ red) battery terminal last.
Reconnect the Positive (+ red) terminal first and the Negative (- black) terminal last.
2. Connect the 1-foot Fused Battery Cable to the vehicle battery.
Post type batteries:
Remove the nuts from each of the two battery clamps. Install the
ring terminals on the bolts, Red Wire to the Positive (+) battery terminal and Black Wire
to the Negative (-) ground terminal. Reinstall the nuts to secure the ring terminals to the
clamps.
Side terminal batteries:
Remove the bolts from each of the two battery terminals.
Reinstall vehicle battery cables using side terminal adapter bolts (see illustration).
Tighten the adapter bolts. Connect the Red Wire to the Positive (+) battery bolt, and
Black Wire to the Negative (-) battery bolt. Tighten the nuts to secure the lugs to the
adapter bolts.
Summary of Contents for CyberTek QUALIFIER
Page 2: ......
Page 8: ...Qualifier System iv This page intentionally left blank...
Page 47: ......
Page 48: ......
