OMM Series
User Manual
Document No.: UM-OMM-2 Rev. A
File Name: OMM Series Optical Multimeter User Guide
Draft
Confidential
i
Disclaimer
Copyright © 2016–2017 © ComSonics Inc. All rights reserved.
No part of this document may be reproduced, stored in a retrieval system, or transmitted, in any form or
by any means, electronic, mechanical, photographic, magnetic, or otherwise, without the prior written
permission of ComSonics, Inc.
ComSonics reserves the right to alter the equipment specifications and descriptions in this publication
without prior notice. No part of this publication shall be deemed to be part of any contract or warranty
unless specifically incorporated by reference into such contract or warranty. The information contained
herein is merely descriptive in nature and does not constitute a binding offer for sale of the product
described herein. ComSonics assumes no responsibility or liability arising from the use of the products
described herein, except as expressly agreed to in writing by ComSonics. The use and purchase of this
product do not convey a license under any patent rights, copyrights, trademark rights, or any intellectual
property rights of ComSonics. Nothing hereunder constitutes a representation or warranty that using any
products in the manner described herein will not infringe any patents of third parties.
(The exclusion of implied warranties may not apply in all cases under some statutes, and thus the above
exclusion may not apply.)
Specifications are subject to change without notice. Every attempt has been made to make this manual
complete, accurate, and up-to-date. Readers are cautioned, however, that ComSonics reserves the right to
make changes without notice and shall not be responsible for any damages, including indirect, incidental or
consequential damages, caused by reliance on the material presented, including, but not limited to,
omissions, typographical, arithmetical, or listing errors in the material.
When you work with this equipment, take the following precautions:
Use of controls or adjustments or performance of procedures other than those specified herein may result
in hazardous radiation exposure.
Never look at an optical fiber using a direct magnification fiber scope without verifying that all laser
sources on the fiber are turned off.
Never look directly into an optical connector.
Install protective covers or caps over connectors when they are not being used. Always assume that
exposed optical connectors and cables are energized.
Always make an optical power measurement of the fiber or connector before cleaning to ensure the cable
and connector are not energized.
